How to Solder SMT ICs and Other Parts



We are searching data for your request:

Forums and discussions:
Manuals and reference books:
Data from registers:
Wait the end of the search in all databases.
Upon completion, a link will appear to access the found materials.

Gather supplies There are some great values online for supplies. Shop around and don't forget to check out Craigslist for used soldering stations if in need of one!

A good iron/tip will last years and years with proper care. Always keep tip tinned when not using or when placed back into stand. Clean and tin the tip often while soldering.

This is a gullwing tip, cleaned and ready to be tinned. Notice the dimple which will hold a pocket of solder and makes soldering fine pitch high pin count ICs quite easy. (chisel tips work too!)

Clean off PCB with rubbing alcohol and a lint free cloth(kimwipes for example). We don't want any dirt getting in the way.

Apply flux to pads, I use quite a bit and will clean the excess off after soldering the IC.

Position the IC making sure its in the correct orientation and location. Once in position tack a couple pins.

This side is tacked and the placement looks good. Let's go ahead and drag solder the other side. Now is a good time to put flux on the pins and pads again.

First we flux the pins, then tin the tip. Then it's just a matter of dragging across the pins at a steady pace letting the tip do the work. If there is a bridge clean tip and redrag over those pins.

Finish the other side and check if there are any bridges if there are a bit of solder wick can clean it up. After a bit of practice the solder wick can stay in the drawer:)

The last step is to give the PCB a thorough cleaning to remove any leftover flux. Flux can be conductive and corrosive so make sure to clean it good. Happy soldering!


Watch the video: How To Repair Damaged Pads,Traces and IC Pins. Soldering


Previous Article

How to Bake Masa Madre

Next Article

How to Make Pete's Breakfast House's Famous Granola